Project Moonwalker

man do I hate spraying....

to get any sort of decent look seems to require lots of coats and sanding in between each.

So far I have done 3 primers, a sanding in between each... and then one black. Going to add a further 2 blacks tomorrow.

Almost finished.... The decals were quite hard getting on and some arrived with bubbles that were very difficult to get out. The big one on the right has about 3 bubbles

Still awaiting on two posters - the marquee and the one for the buttons. Ones they arrive I can put my actual buttons in and set the system up.

Havn't spray the inside drawer as i will be getting a mouse mat. I also need to order the speaker grills too.

I like the right side and front, not so much the left side. I would have the same decal as you have on the right side flipped to fit on the left.

Did you pop the bubbles with a pin and squeegee them? if they're still there they're not bubbles they are creases, try some heat.

Good work and blimey that's a short stick!

I've just ordered a new PC in part to run RetroArch and Bigbox and having a play around. I'd quite like to order one of these in future since I don't really have the room for a full arcade cab.

http://www.ebay.co.uk/itm/CLASSIC-B...eef2e28&pid=100005&rk=1&rkt=6&sd=152259946094

Just waiting for my speaker grills to arrive now... and wire those bottom buttons. Other than that ... this is my finishing look

You can see it in action here