Those with custom loops what speed do you run your rad fans at?

As above, what speed do you run your rad fan's at? Thanks.

I just turn them up and then slowly drop them until the whoosh sound tails off and the rig is quiet enough for comfort.

Tends to be around 800-850rpm. I only turn them up if benchmarking or the game is taxing the system a bit.

I run mine at around 800 rpm which as I have a total of 14 fans across 3 rads in push/pull is enough to keep my system and the water cool whatever I'm doing on the PC.

500rpm on all fans on 2 Rx360v1 Rads fully watercooled system, virtually silent. Using Aquacomputer software

Fans off until Water temp hits 31 'c then the 4 x 220 of the external Radiators spool up, they click off again when temp drops below 29.

As they are low rpm fans to be honest with head phones on I never notice them, even with the headphones off its just a mild air noise and is actually quite pleasant I find

I have Thermaltake TT Premiums' running at about 300RPM at idle, ML120's at about 450RPM idle. The ML120's double under load, the TT's go up to about 800.

That's great, cheers guys.

So I should be ok with my bequiet silent wings 3 1000rpm edition then. Just need 2 more then I'll have 5 in total.

What are your pump speeds at and do you have them adjust to the temp or just run a fixed rpm?

I just run mine at fixed 900rpm.

BriT said:

I just run mine at fixed 900rpm.

Click to expand...

Is that fans or pump mate?

Around 900
2 x Silverstone FQ121WC
2 x Corsair SP120

My D5 is set to 3 I think. Some of my fans stop when idle and then ramp up when cpu starts heating up. Others are just on a low tick over to keep a bit of airflow through the case and ramp up like the others.

Bone9 said:

Is that fans or pump mate?

Click to expand...

Fans.

Double post

I have 4x 140mm areocool DS fans on the rads & run them at 700rpm.
Rear exhaust fan is a 120mm Areocool DS that run at 850 rpm

Pump runs at 50% (2200rpm)

.:SAmSuNG:. said:

My D5 is set to 3 I think. Some of my fans stop when idle and then ramp up when cpu starts heating up. Others are just on a low tick over to keep a bit of airflow through the case and ramp up like the others.

Click to expand...

Your build is gorgeous mate!

800-900rpm for the fans and pumps are set to 3.

450rpm at idle, 800-1000rpm at load with a D5 vario set to 2

Max water temp of 35c with heating on full blast

As it's winter now mine are turned right down so about 450rpm and I currently have a water temperature of 7.6 degrees (was even colder yesterday). My radiators are in a box on a windowsill with the window slightly open and sucking outside air at 2.6 degrees through them. No I do not get any condensation.

As with most others, fans vary between 450rpm and 900rpm depending on load. D5 pump is on the lowest setting.

That's brilliant cheers guys.

Are you all on push pull, push or pull?

My front rad will be push and my top rad will be pull.