Asus Q-Code '0d' on reboots

Scott C · 27 Feb 2019 at 08:37

Hi all,

I've recently put together an FX-9590 system (for science!) however I'm experiencing a couple of issues...

The motherboard is an Asus Crosshair Formula-Z and on reboots I'm very often getting a '0d' Q-Code and only powering the system off and back on again will clear it, cold boots all seem to be fine...

Pertinent specs -

2x 4GB Patriot DDR3-1866 MHz
Sapphire RX580
Corsair RM850x
Cryorig A80 AIO

Does anyone have any ideas or suggestions on what could be causing this?

Thanks,

Scott

Yaayuh! · 27 Feb 2019 at 12:18

That code is unknown. "0C – 0D Reserved for future AMI SEC error codes"

Cleared CMOS and tried different RAM?

Jamin280672 · 27 Feb 2019 at 12:52

Is the PC booting up fine on reboot or is it actually getting stuck on that code ? then having to force reset it to reboot again ?

Scott C · 1 Mar 2019 at 08:43

Hi both,

Thanks for your replies

Apologies for the delay in replying.

I'm hopeful that I've actually made some progress with this now and I my actually be experiencing a few separate issues at the same time!

I've disabled 'Warm Boot', 'Fast Boot' and enabled 'Memory Clear' and thus far this seems to have cleared up the '0d' error on reboots. It also appears that I've got a misbehaving stick of DDR3 which would explain the lockups that I was also experiencing...

I should have some replacement memory arriving today that I will put through a memtest but fingers crossed