Loved watching her in films years ago
Always family friendly
Used to love watching her in old films years back
Time to get a few out in remembrance :(g
For all those supporting buying Asus remember this thread?
Open them up
Some serious magnets in there,very handy on a piece of string to get metal objects you have dropped
Have used this to get my hammer...
Been running for a few hours now temps have not got above 51 oC and showing no errors on mem.....atm anywway even got it @ 3200,timing is pants...
About 42 @100% and 34 ish at idle
depending on weather
Will be putting fan back on soon so will give a better/accurate report then
There are 2 fans,i just removed the 120mm front fan.There is still a 135mm middle fan in place and the 230mm side fan which is practically...
Ok as a test i disconnected the front fan from power and stress tested it with cpu-z ,all cores @ 100% for 15 mins Temps maxed out @ 50 oC
Oh the ram fits fine,but swapping the ram with the fan in place is a no go
I must say that it is likely to be only a temporary measure as after i...
:eek: That Noctua,but that bequiet one is looking good,same manufacturer as my DRP2 too
Thanks for all the suggestions again :D
That Cryorig R1 Universal is more than i want to spend as my DRP2 is working ,i just want more room to get...
There looks to be about 20 mm ish of room over the gfx card to bottom of DRP2
BUT i have an extra usb3 pcix card in top slot,might interfere and i...
Case is a hafx 932 but the DRP2 is only 10mm ish away from the side fan and is right over the ram
Thanks ,still `looks` a bit close to the ram,or maybe it is my eyes:)
Thanks for the reply :)
Yeah the DRP2 was reused from my old system as i thought it was so good at cooling,unfortunately it blocks a lot of the...
I currently have a Dark Rock2 pro cooling my unclocked (atm...
We never ever answer a call,if we hear the person we know we pick up.Life is too short to waste precious seconds telling a cold caller to****...
Yup working for me now too
We got that.works well,long range too
Have you tried entering `Hynix`in the calc?
And why use the Debug mode?
I might not fully understand how the calc works but i cannot get the same...
Separate names with a comma.