Hazro HZ30Wie / Dell U3011 comparison

Associate
Joined
18 Oct 2002
Posts
1,070
Location
Kent
Here is my amateur review of the Hazro HZ30Wie and Dell U3011 monitors. I hope this is useful for anyone considering buying one of these screens.

dh1.jpg


Build quality:

Hazro:

Extremely solid. The stand is very heavy and is a separate piece fixed to the screen with four screws. Given the weight of the screen the stand holds up very well indeed. Very little wobble. The stand is fully adjustable (height, tilt etc) but takes some work to do it – if you need to adjust it regularly then it will be a nuisance. The screen can also be mounted in portrait mode but I can’t see why you would want to with a screen so large.

The height adjustment was problematic. At its lowest setting the screen sits quite high off the desk meaning that I had to look upwards quite often. This may have given me neck ache after extended use.

Dell:

This monitor is fully assembled, literally unbox then plug and play. The stand is reasonably solid but the weight of the screen does make it wobble considerably more than the Hazro. Adjustment wise the Dell wins hands down. The height adjustment, tilt and swivel couldn’t be easier.
Height adjustment is perfect. At its lowest setting the screen is virtually sitting on the desk which for a 30” screen is really where it needs to be.

Height adjustment:

Interestingly when the Dell is set to its maximum height it’s exactly the same as the Hazro at its minimum height (see the first pic). For me that it far too high. The picture below shows the other extreme, the Dell at its lowest and the Hazro at its highest.

dh2.jpg


Picture quality:

Hazro:

Straight out of the box the Hazro is very bright. Lowering the brightness too far causes a strobing effect and therefore needs to be set bright to compensate. I did get used to the brightness very quickly and the colours were sharp and vivid.

The anti-glare coating on the Hazro is visible on light coloured backgrounds but I had no issue at all reading text. For me personally the anti glare wasn’t a problem at all.

My screen had one stuck pixel slightly off centre of the screen which was bright red on a white background. For a budget screen this was to be expected. The pixels are quite small and in general usage I wouldn’t have noticed it very often. It did begin to bother me slightly but only because I knew it was there.

Viewing angles appear to be a problem on this screen. At its lowest setting the bottom 25% of the screen looked darker than the rest. This went away if the screen was moved higher, however it was then too high to comfortably use.

Dell:

The default colour settings on the Dell were spot on. The brightness was a little low on default settings (50 brightness and 50 contrast – I have bumped brightness up to 62).

The anti glare is a little heavier on the Dell but again isn’t an issue for me. White backgrounds look fairly dull compared to the Hazro but this may partly be because of the brightness settings. My screen sits behind a window so the anti-glare is quite useful. There were no issues reading text which was clear and sharp.

The Dell didn’t have a single dead or stuck pixel, which is what I expected from this price range of screen. I’m happy knowing that the warranty covers me should anything untoward develop.

Functionality:

Hazro:

There’s not a lot to say about the Hazro. It has a single DVI-D input and three buttons on the back of the screen, one for power and two to adjust the brightness up and down. That’s it, no settings to adjust, no calibration, just plug in the cable and you’re done. Colour settings would have to be adjusted from the operating system.

The Hazro does not have HDCP support. OCUK have confirmed that all of the Hazro screens they currently sell (as at April 2012) do not have HDCP. This contradicts various sources, including the manual that Hazro supply. OCUK tell me that the screen is HDCP ‘capable’ but this involves buying and installing an HDCP chip.

Heat is an issue on this screen. Once it has been running for a while the top gets extremely hot, enough to burn if you left your hand on there for more than a couple of seconds. This doesn’t affect the screen in any way and it is completely silent. I was surprised about the heat given that the Hazro has an external power block.

Dell:

This screen has it all. Multiple inputs (2x DVI-D, 2x HDMI, VGA, display port, audio) in addition to two USB slots and a card reader. The card reader had no issue reading SDHC cards which is a bonus because my old card reader didn’t like them.

The Dell is HDCP capable and worked straight out of the box. Blu-Rays are a pleasure to watch on a screen this size.

Given that the Dell has an internal power supply is doesn’t generate much heat at all. Much cooler than I was expecting.

The on-screen display is a pleasure to use. The buttons are heat sensitive and light up blue when the OSD is active. They are responsive and each press gives an audible beep, including the power button. I’ve only needed to use the buttons to change source so I can view my other PC or laptop which are also hooked up to the screen.

One strange issue with the Dell is power coming through the DVI-D cable. When my second PC is turned off the CPU fan and any case fans connected to the motherboard continue to spin. I’ve not yet got to the bottom of why this happens.

Summary:

I paid £594 for the Hazro and £810 for the Dell, both from OCUK (thanks to a 10% off voucher from the Facebook promotion). Without any doubt the best screen is the Dell and is worth every penny over the Hazro. This is like comparing a Ford Mondeo to a Mercedes. Although the engine size might be the same the Dell oozes quality and finesse while the Hazro does its job at the most basic level.

I was led to believe that the Hazro had HDCP and this was a deal breaker for me and the reason for returning it under DSR. I’m actually pleased I ended up replacing it with the Dell because nothing on this screen niggles me other than the slightly wobbly stand.

If you can afford the Dell then don’t hesitate in buying one. The additional cost is worth it for the numerous outputs, OSD and exceptional warranty. If you only have enough money for the Hazro 30”then give serious consideration to getting the 27” Dell as an alternative.

And finally a pic of both the 30” screens behind my beloved 5-year-old 22” Dell, just to show how massive these screens are.

dh3.jpg
 
nice review im suprised at the dell stand being wobbly tho mine is the u2711 and the stand is so solid its like stuck in concrete maybe the extra width just takes it past the point of balance nice review tho and yes the build quality and other factors make the dell will worth the expense
 
Nice write up.

I agree with your findings about the stand on the Dell. Nice to use, but I wish it was a little stronger. My left leg 'jiggles' a lot when I am sitting down (something like Restless Leg Syndrome) and it makes my U3011 wobble up and down.

For comparison, my HP LP2475W doesn't move at all, although at 24 inches, the screen doesn't weight as much.

Having said that, it is a minor annoyance at best, and the rest of the screen, like derv said, is excellent and well worth the money if you can afford it.
 
If you already had a Hazro and were looking at adding a second monitor - would you go for another so you have two identicle monitors or the Dell because its so superior?
 
how are they for gaming?

I have only tried gaming on each of the monitors for an hour or so. Both were fine. I didn't notice any ghosting on either screen, although to be honest I never tried a fast paced FPS to see how it coped. I was more in awe of the huge resolution to notice anything bad :D

If you already had a Hazro and were looking at adding a second monitor - would you go for another so you have two identicle monitors or the Dell because its so superior?

Having now used both I would personally go for a Dell without a doubt. The Hazro would be used as a secondary screen or sold to fund another Dell.
 
Last edited:
Mmmm very usefull info Mr derv sah, i could well have opted for the hazro as i will be on a budget at the end of the month. Think i will save another month and get the dell instead Cheers :)
 
Nice review, thanks for taking the time to post it and pictures.

As someone who is looking for a bigger monitor the things that elimate the Hazro from my choices are the lack of inputs (need DVI and Display Port for my 2 sources), the minimum height of the stand, and the lack of picture adjustment.

Hmm, the Dell 30" at 2560x1600 or a different 27" at 2560x1440... savings to be made on a 27" and need to take in to consideration the extra gpu processing power required to drive games on the Dell. But 30"'s.....

And they just bumped the price of the Dell up £50 :(
 
Nice review, thanks for taking the time to post it and pictures.

As someone who is looking for a bigger monitor the things that elimate the Hazro from my choices are the lack of inputs (need DVI and Display Port for my 2 sources), the minimum height of the stand, and the lack of picture adjustment.

Hmm, the Dell 30" at 2560x1600 or a different 27" at 2560x1440... savings to be made on a 27" and need to take in to consideration the extra gpu processing power required to drive games on the Dell. But 30"'s.....

And they just bumped the price of the Dell up £50 :(

I was going to get the U2711 through OcUK today - until I saw it was now £600. So I got it from a competitor instead for just £505 (which is the latest A11 revision)
 
It's £863.99 from one particular supplier, however they are currently out of stock. Or £885 from the rainforest place.

Hope OCUK aren't following Tesco tactics, raise the price this week then sell it on 'this week only' at a £50 discount :D
 
Interesting comparison - thanks for taking the time out to post the mini review. I wanted to explain a little about the 30" displays:

In terms of inputs (or lack of), we could easily have plucked the Displayport + HDMI controller from the HZ27WD and incorporated it into the 30" displays: the cost of doing so would have increased the RRP by about £50. Throw into that a cheap inexpensive USB 3.0 hub/memory card reader etc. and it would make the entire monitor comparable to other brands.

However:

Apart from small lots that are sold via resellers, the 30" Hazro monitors are bulk buy units i.e. companies specify what they want and we build accordingly. When rolling out 30~50 units in one company, factors such as ROI and cost of ownership are deal breaking factors and this is where the Hazros win. Specs given to us are straightforward: build a 30" monitor for as little as possible. Most of our buyers require single inputs only as the WQXGA resolution, when split, serves no purpose in everyday use (1280x1600 is a commonly used res in the medical industry so we have a model with a built-in scaler for that market). Also, PIP on a 800x600 window is seen as a nuisance. As for OSD (or lack of), our clients have 3rd party calibration utilities and with the backlight/temp/gamma factory set, better results can be achieved than digital controls such as 'sharpness/contrast'.

A LED WQXGA 30" is due next year and we may consider going all out with multiple inputs etc.
 
I was going to get the U2711 through OcUK today - until I saw it was now £600. So I got it from a competitor instead for just £505 (which is the latest A11 revision)

it went from 509 to 507 to 505 in one week mine was 507 so they are dropping a10 should be under the 500 mark in a week tbh as the a11 are about 500 - 505 atm

may as well get the a11 at 500 quid i guess.

not sure what the diferences are but if u can get the latest rev at the right price may as well
 
it went from 509 to 507 to 505 in one week mine was 507 so they are dropping a10 should be under the 500 mark in a week tbh as the a11 are about 500 - 505 atm

may as well get the a11 at 500 quid i guess.

not sure what the diferences are but if u can get the latest rev at the right price may as well

Dell don't release the notes on revisions (apparently) for some reason. However, I can't imagine they've made the monitor worse from A01 -> A11.
 
Interesting comparison - thanks for taking the time out to post the mini review. I wanted to explain a little about the 30" displays:

In terms of inputs (or lack of), we could easily have plucked the Displayport + HDMI controller from the HZ27WD and incorporated it into the 30" displays: the cost of doing so would have increased the RRP by about £50. Throw into that a cheap inexpensive USB 3.0 hub/memory card reader etc. and it would make the entire monitor comparable to other brands.

However:

Apart from small lots that are sold via resellers, the 30" Hazro monitors are bulk buy units i.e. companies specify what they want and we build accordingly. When rolling out 30~50 units in one company, factors such as ROI and cost of ownership are deal breaking factors and this is where the Hazros win. Specs given to us are straightforward: build a 30" monitor for as little as possible. Most of our buyers require single inputs only as the WQXGA resolution, when split, serves no purpose in everyday use (1280x1600 is a commonly used res in the medical industry so we have a model with a built-in scaler for that market). Also, PIP on a 800x600 window is seen as a nuisance. As for OSD (or lack of), our clients have 3rd party calibration utilities and with the backlight/temp/gamma factory set, better results can be achieved than digital controls such as 'sharpness/contrast'.

A LED WQXGA 30" is due next year and we may consider going all out with multiple inputs etc.

while some people might like a lot of inputs like you mentioned many people dont need em. I bought the hazro because of the less lag/cheaper price - waiting for it to reach me (had issues with ocuk and the delivery service) so hopefully Ill get mine today and can give my input.
 
It should also be noted that the card reader on the Dell is an xD/SD/MS/MMC one, and not the 7-1 (or 9-2) mentioned on the OcUK website.

Still, SD should be enough for most people and it is a nice addition to have. The two USB connectors on the left hand side are also conveniently placed.
 
Back
Top Bottom