antec fusion remote owners help

johnny sublime · 10 Sep 2009 at 19:10

will the fusion take full height gfx cards or low profile

Matty_Boy · 11 Sep 2009 at 09:29

I have a Fusion Mk1, not a remote, but I'm pretty sure the internal dimensions are the same.
I've got a Sapphire 4870 1GB card fitted inside mine, height is fine, just be careful of card length as I had to trim away a bit of the hard-drive enclosure wall to fit the power cables into the end of the card!

PistolPete · 11 Sep 2009 at 15:32

I have the Fusion Black - the fusion with the LCD display.
It takes full height cards, but yes, watch the length

johnny sublime · 11 Sep 2009 at 22:38

dose any1 no the max dimentions are for the cards

Matty_Boy · 22 Sep 2009 at 14:05

Another thing to be careful of is where the power connectors for the graphics card are located, if they are on the side of the card (for example like a GTX 280) and not the end, you may run into case height problems with the power cable connections.

Guardsmon · 22 Sep 2009 at 14:33

bit of a bum there... you had problems matt?

Matty_Boy · 23 Sep 2009 at 16:44

Not currently as I use a Sapphire 4870 which has the connections on the end. I did, however, have to cut a gap through the hard drive enclosure wall to get the lower power plug in due to length restrictions. I may well remove the entire wall and hard drive enclosure moving forwards as all my media now resides on a WHS. This will allow new longer cards such as the ATI 5870 to fit (will have to check height restrictions on this as power plugs are now on the side of the cards!). The OS hard drive can be located behind the display above the DVD ROM using a 5.25 to 3.5" adaptor.