Asus Maximus V Formula Preview/ Results/ everything Thread!!!

Just overclocked a 2700k on one of these boards 8 Pack - 5.2Ghz on air easy @ 1.45v. Probably a pretty decent chip, but belter nonetheless. Thanks for your email mate - will get back to you later this afternoon. Phase change still hasn't arrived from LD though! :(

D
 
I have set up raid in bios and have windows installed on two raided ssds.I have another two ssds on the Intel 3gb ports.I want to set them up as raid also but the rst control centre won't open
 
Last edited:
DamoTourettes said:
Just overclocked a 2700k on one of these boards 8 Pack - 5.2Ghz on air easy @ 1.45v. Probably a pretty decent chip, but belter nonetheless. Thanks for your email mate - will get back to you later this afternoon. Phase change still hasn't arrived from LD though! :(

D
Click to expand...

Bring your kit to me then I have several units. SR2 on dual cascade please.
 
Here's a weird one 8 Pack - so I've got the 3 x PCIE slots on the board -

#1 I have populated with a proprietary card that I want to run at x8

#2 I have populated with another proprietary card that I want to run at x8

#3 I have a standard PCIE video card that I want to use as the default video out on the mobo.

Unfortunately it appears that unless the mobo recognises an Nvidia or AMD chip in the x16 slot (#1) I can't get any video from the box at POST. What gives?

Cheers in advance as per usual :)

D
 
Responded your e-mail mate.

You can only get 8x 4x 4x from that board all lanes are CPU and no added Chip. The MVE can give you numerous scenarios as it employs a PLX chip to give you far more GPU PCI EX lanes. Similar to the MIVE I believe your benching against but PLX is much better than the old NF200 controller.
 
Sorry to hijack this thread a little bit but wondered if any of you were having voltage reading issues with the maximus v formula? My board reads the DRAM, PCH, PLL, VCCIO and VCCSA voltages as 3.196v which would easily breakl my components. I did check these voltages with a multimeter with the read points on the MB and the actual voltage is what I set it at.
Just wondered if you could take a look at my thread:
http://forums.overclockers.co.uk/showthread.php?t=18448610

Thanks in advance,
 
8 Pack -

Thanks for the response and yea I agree that AISuite is a pile of crap.

I use HW monitor myself however it doesnt read those voltages. And im pretty sure its not a software issue as the BIOS itself is reading the same voltages.
Regards,
 
You must log in or register to reply here.
Back
Top Bottom