Can't wire up the Parvum systems, Vandal Switch Power LED light

Jay85 · 3 May 2013 at 14:02

Here are 2 images i got from the web:

I have circled them in red to help you better understand my problem..

My power LED looks like this:

and my motherboard front panel header looks something like this circled in red again for the PWER LED:

As you can see a 2 pin will not fit in a 3 pin because one of the wires will not make contact to the front panel header therefore it will not light up. I have wire up the power connectors easily no problem but struggling to find a way to wire up the LED due to the connectios.

Please help 8pack as i know you have the same case and board.

Jay

Jay85 · 3 May 2013 at 17:04

8 Pack said:
Hi mate for power led I just cut off the end and soldered the wires directly onto the EZ plug that comes with the board.

Is there a more easy and subtle way to do this? I dont have a solder

Jay85 · 4 May 2013 at 17:26

Haha! Proper winging it! Okay i'll give that a try then and just bend the pins.

Was actually thinking about cutting the plastic plug in half with a dremel lol

Jay85 · 5 May 2013 at 16:49

used your method for the time being and it's working fine

Thanks!