DFI LanParty UT nF3

Gwyn

Gwyn

Gwyn

Associate
Joined
9 Feb 2004
Posts
1,115
Location
wales
Hi guys
I was wondering if anyone knows how to change the voltage to the cpu on this board.
I know where the settings are but they are on auto and I can find where the setting is to turn them onto manual.
here is the spec

DFI LanParty UT nF3 250Gb
AMD Sempron 64 3100
Corsair 512mb DDR XMS3200C2PT Platinum
Ati 9600xt

Thanks
 
The setting I want to change is the cpu volt as I have got the cpu stable at 260 fsb with out changing the volt from 1.4 but when I go any higher it fails prime95 so I need more power however the setting I need is coloured blue which means it cant be changed without changing something ells first.
I have gone through all of the settings and there is no setting to change from auto to manual.
Im sorry if im being really thick here but on my abit board all i have to do is put it to manual and I can change the volts, so where is this setting on this board.
 
yes very much so
Thanks so much for the help
Im just not used to this bios
Iv almost got my 3100 sempron running at 2.43
Its still failing the second test on prime so I think it need a bit more power
how much can I give this chip using a referance h/s
Thanks again
 
Hi guys
Just a quick ocing Q
I have got my pc to boot into windows at these settings but it keeps failing prime 95

280/9 @ 2.52 1.55v
my pc3200 is running with a 133 divider @ 2-3-3-6 frequency 180 MHz

It was stable with a 166 divider @ 2.5-3-3-7 running @ 270/9

Any ideas
Thanks
 
This is the memory im using. Its one stick of 512

Corsair 512MB DDR XMS3200C2PT Platinum CAS2

Its now stable on Prime95 after an hour. and the temp goes upto 47c
Its running at 280/9 @ 2.52
The cpu volt is set to 1.500/110%
When im running prime it goes upto 1.66. Is this ok or is it a little high.
When idle the cpu temp is around 35c
 
You must log in or register to reply here.
Back
Top Bottom