EPoX EP-9NPA+ '7f' postcode

Unconditional

Unconditional

Unconditional

Permabanned
Joined
19 Dec 2005
Posts
474
Motherboard boot problem

EPoX EP-9NPA motherboard '7f' postcode


I looked up the error code and I get the following text:

1. Switch back to text mode if full screen logo is supported,
-if errors occur, report errors and wait for keys,
-if no errors occur or the F1 key is pressed to continue:,
Clear EPA or customization logo.
Click to expand...

Nothing shows up on the screen but all the fans are spinning etc. I've tried pressing f1, and tried holding down DEL/INS.

I'm running this along side a 3700+ and a 6600gt and 1gb 3200 RAM.

I have tried resetting the CMOS, and also unplugging all IDE drives, but Ialways get the same errors.

Would a bios update help? I have no floppy drive so would I be able to update the bios?

(I have a CD drive)

I have googled this error code and there doesn't seen to be a single correct solution for this problem.

Any help appreciated.

Thanks
 
Last edited:
It does have a 4 pin block, but that is for a plugging into a seperate socket on the motherboard.

Is the fact that I don't have the correct plug/socet combo likely to have caused the problem I'm getting?
 
Its a '500W golden silent'

It has a 20 pin plug, as well as a 4 pin plug, however the motherboard has a seperate socket in which the 4 pin plug needs to be plugged into. The motherboard manual says that both the connectors (pw1 and pw12) must be used simultaneously.
 
You must log in or register to reply here.
Back
Top Bottom