h100i screw driver slipped on radiator

carnivore · 8 Dec 2019 at 16:13

my screw driver slipped tightening in screws to hold radiator on to case its th h100i rgb silver platinum worried I might have messed it up it bended in two of the groves on rad

Minstadave · 8 Dec 2019 at 16:18

If it's not leaking it's fine. You can mangle the fins quite a bit without hitting water channels.

Put a picture up if you're worried.

carnivore · 8 Dec 2019 at 16:51

HoneyBadger · 8 Dec 2019 at 16:53

Looks cosmetic only.

Steampunk · 8 Dec 2019 at 17:04

carnivore said:

That'll be fine. Liquid doesn't run through there, it's only a few bent fins that are just there to increase surface area for the air running through the radiator.

carnivore · 8 Dec 2019 at 17:04

ok good ill continue on thanks

carnivore · 8 Dec 2019 at 17:12

cheers pal was nervous there for a min

Journey · 8 Dec 2019 at 18:41

Were you using a Swiss army knife screw driver?

A few round here will get the joke, I am sure.

Matt_West_Mids · 8 Dec 2019 at 19:01

Journey said:
Were you using a Swiss army knife screw driver?

A few round here will get the joke, I am sure.

The Verge?

Journey · 8 Dec 2019 at 19:17

Matt_West_Mids said:
The Verge?

Aye.