stinkas watercooled wooden case

stinka · 25 Jun 2007 at 22:42

stinkas watercooled wooden case project

ok i thought id start my project off with a couple of plans i knocked up in paint i should have inverted the plan left to right but you'll get my drift

i was going to install watercooling into my modded p160 as mentioned in the other thread, but im going to build a nice big case from scratch :cool:

i will flow watercooling res>pump>cpu block>rad>res

i was toying with getting some oak but it would cost £60 +

so im doing it from mdf as i like the "speaker" type look and its harder wearing than a soft wood like pine, with a perspex side panel, front ports will be like my p160 front panel

any suggestions, comments welcome

thanks

gt_junkie · 25 Jun 2007 at 22:44

Can't wait stinka.

Was seriously impressed with your P160 so i'm sure this will be great!

Best of luck with it pal! :cool:

gt

Azza · 25 Jun 2007 at 23:02

Looks good stinka.

Im thinking of doing a case out of wood over the summer.

Just not sure on wood type, thinkness and stuff.

Will enjoy watching this coming together.

vincent1989 · 25 Jun 2007 at 23:25

course you will need a whole new PC to go inside, why not drop by GH and post a spec me thread

stinka · 26 Jun 2007 at 07:03

bringerofdecay said:
course you will need a whole new PC to go inside, why not drop by GH and post a spec me thread

not really mate my 680i based system will do the job over 12k in 3dm 06 is no slouch

in autum ill prolly be looking at a p35 based setup

naudiz · 26 Jun 2007 at 07:32

Looks pretty sweet man, keep us updated

Naud