Sythe Kama Bay + Antec P182 = FAIL?

Soldato
Joined
4 Feb 2004
Posts
5,881
Hi guys, just looking at this, would go perfect below my DVD/RW drive.

But i keep hearing that it doesnt fit properly in the Antec P180, i can only assume its the same for the P182, does anyone have any experience with this combination?

Cheers guys
 
I know the P182 has those weird drive rails that slot into the grooves to hold drives on place, the Kama bay may not fit because of this.

But I haven't used one myself sorry.
 
My P180 worked fine with the Kama.

Best solution if you want it totally secure is to fasion a brace across the rear screw holes of the brackets to hold them in place.

gt
 
My P180 worked fine with the Kama.

Best solution if you want it totally secure is to fasion a brace across the rear screw holes of the brackets to hold them in place.

gt

Interesting, thanks for this, not quite sure i follow you about the bracket, you had to fashion something like this to get it to fit?

Cheers
 
Interesting, thanks for this, not quite sure i follow you about the bracket, you had to fashion something like this to get it to fit?

Cheers
No, i didn't find i needed to but i could see how it wasn't sufficiently secure for some.

The bracket would go horizontally accross from one rail (lower left side) to the other (lower right side) to keep the rails spread at the rear - then repeat for the rear of the upper rail. Of course they're held apart at the front as the kama bay is there but the rear ends can easily flap about.

gt
 
Back
Top Bottom