• Competitor rules

    Please remember that any mention of competitors, hinting at competitors or offering to provide details of competitors will result in an account suspension. The full rules can be found under the 'Terms and Rules' link in the bottom right corner of your screen. Just don't mention competitors in any way, shape or form and you'll be OK.

Full loop now cpu is useless?

RJC said:
Real temp will be more believable, if your room is at 20c then the minimum water temp would be 25c if all was balanced and sized ok.
Click to expand...

But, Saying I've seen the temps drop as low as 18c on realtemp before during idle. So its got me wondering now if realtemp is off reading.

Is there any other temp programs?
 
Techen said:
But, Saying I've seen the temps drop as low as 18c on realtemp before during idle. So its got me wondering now if realtemp is off reading.

Is there any other temp programs?
Click to expand...

Try HW Monitor.

The software program's are looking at array of sensors so variations can occur with software revisions and calibration of thr sensors.

Ideally you need to test the full load temps.
 
RJC said:
Try HW Monitor.

The software program's are looking at array of sensors so variations can occur with software revisions and calibration of thr sensors.

Ideally you need to test the full load temps.
Click to expand...

Looking at HWMonitor now, It's saying 40cs while playing a steam game. Not bad .

As for testing full load temps, Am scared. After seeing it 86c am not entire sure how far I'd let it run at those temps.
 
10 seconds after running prime

Untitled-13.png
 
Does using the outlet as the inlet on the CPU block make any diff on that kind of block (not sure off that pic or block if it actually makes any diff though) as wouldnt it be going through the jet plate the wrong way on that loop as it is now?
Although like I said not sure if it makes that big a deal tbh or if its relevant to that block?
 
Last edited:
davieg said:
Does using the outlet as the inlet on the CPU block make any diff on that kind of block (not sure off that pic or block if it actually makes any diff though) as wouldnt it be going through the jet plate the wrong way on that loop as it is now?
Although like I said not sure if it makes that big a deal tbh or if its relevant to that block?
Click to expand...

On these blocks there are no in and out so I dont think it matters.

Gonna open it up later today and clean it anyway.
 
there is an in & out on that block look at the little instruction sheet. the in hole has a little plate across out is empty
 
yes last week I installed the same block just nickel although there is no marking on the block my instructions pointed it out don't know how much difference it would make to temps though:D
 
queeg said:
yes last week I installed the same block just nickel although there is no marking on the block my instructions pointed it out don't know how much difference it would make to temps though:D
Click to expand...

Funny enough, I did switch tubes when I fitted the other rad, Didn't think it would make a difference but now... Am starting to think
 
You must log in or register to reply here.
Back
Top Bottom