Linksys wag354 and Tiscali

Associate
Joined
1 May 2003
Posts
501
Location
Blackpool Lancs
Does anyone run this setup who can post there router settings?

I have spoken to tiscali at length and cannot make the connection work. The router says showtime and its TX RX speeds, the dsl light is on but the internet light is not?
Tested with a modem and all is fine. But tiscali dont have aclue about half the settings on the router QOS type etc..

Anyone able to help?
 
Check that the VPI/VCI settings are correct (VPI = 0, VCI = 38) and that you're trying to use PPPoA authentication. Also check that VC based multiplexing rather than LLC based.
 
I set up the same router on Homecall (Tiscali are the ISP). many of the settings ar ok on auto but check the details below

It should be straightforward.

Check you have a DHCP server running on the router and an automatic IP on your network card

check your email address and broadband password (case matters!)


[font=Arial, Helvetica]Virtual Circuit Identifier - VCI[/font]

[font=Arial, Helvetica]38[/font]

[font=Arial, Helvetica] Virtual Path Finder- VPI[/font]

[font=Arial, Helvetica]0 [/font]

[font=Arial, Helvetica] Encapsulation Mode[/font]

[font=Arial, Helvetica]VCMux [/font]

[font=Arial, Helvetica] Authentication Type[/font]

[font=Arial, Helvetica] CHAP[/font]

[font=Arial, Helvetica] Protocol[/font]

[font=Arial, Helvetica] RFC 2364:PPP over ATM (PPPoA)[/font]

[font=Arial, Helvetica] Modulation Type[/font]

[font=Arial, Helvetica] G.DMT or Auto[/font]

[font=Arial, Helvetica] Primary DNS Server[/font]

[font=Arial, Helvetica] 212.74.112.66[/font]

[font=Arial, Helvetica] Secondary DNS Server[/font]

[font=Arial, Helvetica] 212.74.112.67[/font]
 
Back
Top Bottom