Search results

You can crush/grate the fatballs and spread them around the grass / ground. They horde will still decend on the the garden, but it will slow them down a bit. They'll also have a rummage for insects while they are at it. I made wire mesh cages to go around various feeders to allow smaller birds...

Not true, every farmer I know has an emotional attachment to their herd. The hardest of farmers still have favorites and "pets" that their children helped to raise. Even more so with dairy herds where the farmer will probably have helped deliver many of them. They are not just a source of income.

Do not start chasing out the mortar. Leave it alone, it's doing important work:) Use mini trucking along the skirting to the corner and then up to the TV. You'll find something suitable on Screwfix https://www.screwfix.com/c/electrical-lighting/cable-management/cat1150038

Go into the brick, mortar is not suitable for taking a load. You can get a hammer drill for £25 from screwfix. Well worth having one.

Just an update on this. AMD Rewards has confirmed that the retailer (Not ocuk) had not issued a valid coupon code. I got a new one from the retailer today, which was accepted by the AMD Rewards site only to get a message saying that the Coupon Code limit has been reached ! I'll keep following...

Thanks for the tip. Still get invalid coupon in the verification tool so maybe there was a typo in mine. Have logged a support ticket so hopefully it gets sorted.

:) I did check that. You redeem it now and download on release.

My 5800x showed up yesterday. Finally able to finish the new build and test everything. I tried redeeming my Far Cry 6 coupon but the AMD Rewards site says it is invalid. Anyone else have any issues with theirs ?

Looks nice. You should be able to repair that chip handy enough. I'd love an air rifle for plinking in the back garden, but all air rifles are licensed the same as rimfires over here. So no shooting from the kitchen table :).

DublinDude is in the Irish Republic, so after Dec 31st he'll probably have to pay Duty and handling fees etc. This will be collected by the postal courier before delivery. Same situation as we currently have with ordering from the US for example. I received an email today from our national...

Standard red plugs will be fine. I prefer to mount treated roofing battens vertically to the wall with plugs & screws. I can then screw the trellis to the battens.Drill pilot holes in the trellis to avoid splitting. This method makes it easier to adjust the trellis if it's not level or has...

Not sure which diagrams you are referring to. Link as an example. Fig 1 shows the circuit schematic, Fig 2 shows how it's wired (including cable colour, switch terminals etc) http://www.lightwiring.co.uk/two-way-switching-3-wire-system-new-harmonised-cable-colours/ If you can't follow those...

First you'll need to take all the switch face plates / ceiling rose off to see how the lighting circuit has been wired. Once you understand that you can decide on the best way to modify it. This site has all the information you'll need http://www.lightwiring.co.uk . As always, if you are anyway...

I know this job isn't notifiable, but it would make sense to ask a qualified electrician. Screwfix have a decent forum that I have used in the past.

That's a shame. I think the furniture pads rely on there being a decent amount of weight to get friction.

If you are unsure, just try it again. There are a few good guides for this on Youtube. Clear CMOS (may not be needed on a new board), plug your USB drive into the correct BIOS update USB port, press button. led starts flashing and you wait for the system to restart. I think mine took about 4...

Have you tried roughing up the bottom of the pads with coarse sandpaper? It might take the slippy surface off and provide extra grip.

Got a confirmation for my 5800x. All going well I'll get it next week.

I couldn't make it through S03E01. I don't know if it's the actor or just the Burnham character, but I can't watch them anymore. I find myself cringing constantly.

Re-handling that will be an easy project. Nice bit of scrap hardwood out of the firewood pile and a few of coats of Tung oil is all you need.