I have this board which has built in usb 3.0, but as yet cannot get any usb 3.0 devices to run a super-speed.
Machine is giving notifications saying this device will work better if connected to super-speed usb 3.0 port.
Device is a Blackmagic intensity Shuttle.
It's connected the correct USB 3.0 ports.
USB controller has been updated with the newest firmware and drivers.
I have the board running at I/O level up usb 3.0 mode, which drops the PCIE x16 to x8.
Has anyone with this board managed to get usb 3.0 working?
Machine is giving notifications saying this device will work better if connected to super-speed usb 3.0 port.
Device is a Blackmagic intensity Shuttle.
It's connected the correct USB 3.0 ports.
USB controller has been updated with the newest firmware and drivers.
I have the board running at I/O level up usb 3.0 mode, which drops the PCIE x16 to x8.
Has anyone with this board managed to get usb 3.0 working?