Panflo

Steve_h · 4 May 2006 at 21:09

Just managed to track down and buy a NMB-MATFB-120-L1A,if anyone has one is it ok to 7volt it and what sort of rpm's are they getting from it?
Ta

clone · 5 May 2006 at 08:47

Cannot see why you will have any trouble m8 i run my panflo`s(FBA12G12M) on a fanbus at low rpm.

dragonball · 5 May 2006 at 09:07

http://www.panasonic.com/industrial/appliance/pdf/fba12g.pdf

Operating voltage 7 to 13.8v

Chart will give you an rpm depending on pressure, looks like 1000/800 rpm

dazza121 · 5 May 2006 at 16:23

They run very well at 7v i have an L1a and and 2 m1a's running at 7 volts and they are very quiet and push more air than the Akasa Ambers that i had previously at the same noise level

Steve_h · 5 May 2006 at 21:02

thanks for the info,just need to sacrifice an old 120mm now to make my rad shroud now