11700K OC Advice?

Adam1712

Adam1712

Adam1712

Associate
Joined
5 Apr 2021
Posts
5
Hi! New to the forum sorry if this is in the wrong place!..

In short, I'm just setting up my 11700K, ROG Z590-E MB and CM360ML AIO.. I'm happy with the general BIOS settings and am just fine tuning the final numbers, going for an all core stable OC I'm at..

VCore - 1.3V (Manual)
Ratio - 48 (-2 AVX Offset)
Temps - 79C (91C with AVX) (27-33C at idle)

These are based on 10min P95 small fft.

I can push 5.0 with 1.39V but I have to drop the AVX to -6 (maintaining 4.4) otherwise AVX temps skyrocket.

Just wondering what your thoughts are? Is it worth the extra voltage for the extra 0.2 OC, will be used for gaming only!

Thanks! If you need any other info please let me know!
 
Grim5 said:
Based on these numbers you will in fact, lose gaming performance. The only way to match or beat stock gaming performance on the 11700k is to get an all core of 5.1ghz or higher. If you cannot do that, leave it stock, you're wasting your time
Click to expand...

It’s taken me all weekend to figure this out, but I don’t think this is true, hear me out..

Under ‘intel’ stock settings, you get the 5.1 boost for a minimal amount of time on limited cores, then everything drops back (can’t remember the numbers exactly but between 4 and 4.5 I think!)

If you leave everything stock but enable the ASUS settings (MCE I think it’s called) then you maintain the 5.1 but at absolutely absurd voltage and temps, nothing I was comfortable leaving permanently.

So.. I figured I’d try for an all core ‘middle ground’ OC, I’m upgrading from a 2600k system I built 10 years ago so the 10/11 series argument is a bit irrelevant to me, it’s a massive upgrade either way!
 
Steve Hel said:
I wouldn’t bother with an AVX offset. Probs best just to go to 4.9 or lower all core for better temps/lower voltage. The performance increase for say 5.1 if you could hit that wouldn’t be worth the heat.

I don’t agree with leaving it at stock due to the voltage and heat over an overclock or undervolt.
Click to expand...

I need the AVX offset to get anywhere near 5.1 or 4.9 (if I'm testing with AVX at least!) as I can't get AVX over 4.6 without 1.35V+

I've seen the other comment about not using P95 tests, I've always been on the side of 'if it isn't stable in ALL situations then it isn't stable at all' but I've also not been overclocking for the last 6/7 years what's the opinion on that? I think I could get 5.0/5.1 on non AVX pretty easily my issue is..

To get 5.0/5.1 i have to increase V to 1.34 or so, which I'm okay with, but it means when I run AVX tests (even with an offset to keep at 4.6) the extra V puts my temps too high (i.e. 4.6 @ 1.29V is much cooler than 4.6 @ 1.34V)..
 
MartinPrince said:
This.

Rocketlake seems very much like Ryzen 3K/5K in that they've had the 'single core' speeds almost fully maximised at stock settings.
Click to expand...

I'm no pro by any means but I agree with this.. I think about the best you can expect is getting an all core OC to the level of the stock single core... Within reasonable temps/voltages anyway! I thin the advertising is a bit misleading anyway though.. 'Stock' does not hold a single core at 5.1 for any meaningful amount of time, its like building the worlds fastest electric car but only giving it half a mile range!
 
You must log in or register to reply here.
Back
Top Bottom