2600k Overclock Temps

[Antony101]

I'm using a P8P67 Pro REV 3.1 with a 2600k. Cooled by a H100 with 2x120mm fans, are these good temps and safe to run at or? I know I only run Prime95 for 17 minutes but meh, seemed okay.



Thanks, Antony

 

[Antony101]

I now have the same temps running at 4.6Ghz, the H100 is on low yes, turning it up doesn't seem to help and it's stupidly loud, I cannot afford new fans at this moment in time so will have to make do, I was a bit suspicions of the temps as I thought the H100 would do a better job but even at stock speeds it gets to 60ish on 100% load.

Thanks, Antony

 

[Antony101]

Hmmm, I'm sure it's mounted right, tightened up the 4 screws as much as I could without over doing it. I'll have a look when I next get the chance to move it, small room and this case is heavy as hell. I should be safe at around 75 degrees under 100% load shouldn't I?

 

[Antony101]

The voltage has been reduced to get me to 4.6Ghz.

 

[Antony101]

Sounds like I may have gotten a bad one

 

[Antony101]

I'm no longer running that Vcore, it is now set to auto, I'll fiddle with it at some point. Not sure of my ambient, it seems like it reaches the temps of the PC after a while ahah.

 

[Antony101]

1.344V according to CPUZ on an overclock of 4.6Ghz.

 

[Antony101]

Can you link me to burn test, not sure what site is legit on google.

 

[Antony101]

It hit 75 degrees using burn test and at times stayed at 63ish for a minute and then went back up.