Hi, how important is this voltage to be above 3v? Bios reads 2.8-2.9v multimeter reading is 2.98v idle then 2.88 under load. Just started having some weirdness with my second rig yesterday so currently troubleshooting.
PSU: - Tagan TG480-U01
Mobo:- MSI K8N NEO2 NFoce3 Ultra [Socket 939] AGP // opty 146
Yesterday my usb ports [2 front 4 rear] started acting up, 2 at front and 2 at rear are dead, 1 is ok and 1 is intermittent. In device manager under usb it says unknown device where there used to be [ I think] a usb root hub.
then today out of the blue my Adaptec ASH-1205SA SATAConnect Serial ATA Controller card was acting up. Windows reports not enough resources for it to work, despite I'd been using it just 20 mins earlier. Pc had shutdown. I've removed it for the time being and put the 2 hdd it was controlling onto the mobo sata controllers [sata1 and 2]
I've loaded optimized defaults for the bios, previously it was running a small overclocked setting.
PSU: - Tagan TG480-U01
Mobo:- MSI K8N NEO2 NFoce3 Ultra [Socket 939] AGP // opty 146
Yesterday my usb ports [2 front 4 rear] started acting up, 2 at front and 2 at rear are dead, 1 is ok and 1 is intermittent. In device manager under usb it says unknown device where there used to be [ I think] a usb root hub.
then today out of the blue my Adaptec ASH-1205SA SATAConnect Serial ATA Controller card was acting up. Windows reports not enough resources for it to work, despite I'd been using it just 20 mins earlier. Pc had shutdown. I've removed it for the time being and put the 2 hdd it was controlling onto the mobo sata controllers [sata1 and 2]
I've loaded optimized defaults for the bios, previously it was running a small overclocked setting.
Last edited: