360 Rad fan wiring

[big_ray_t]

I am hoping to run my 3 120mm rad fans from a single fan controller output so I have control over them as a unit instead of individually. Is this possible simply by wiring the 3 in parallel to one 3 pin header plug then into one of the controller channels or would there be a power issue?

If not, any other way of controlling all three as a singular unit???

 

[big_ray_t]

Cheers, will connect all the colours together later and terminate into one plug and see how it goes. Will make my wiring a lot easier to handle.

 

[big_ray_t]

May be easier if I just have them on a perm 12v feed then so they run full speed constantly. I suppose it would keep the temps lower and they do seem incredibly quiet