4930k help

Falconik

Falconik

Falconik

Associate
Joined
6 Dec 2008
Posts
270
Hi everyone, thanks in advance for any help/advice.

My system is:

4930k Currently at 4.5ghz
Asus Rampage Extreme IV
2 x powercolor PCS+ 290x
16GB (2x8GB) Vengence black 1833mhz
Superflower 1300+ Leadex

Ok, so basically im trying to overclock my cpu. I have it at 4.5ghz with 8Packs settings from his guide and is stable. My Vcore is currently set to +0.040 which brings me to 1.365 under load. Im very new to offset so don't actually know wether i've got it right but thats the first number i hit when it becomes stable.

Now, after 4.5ghz its like i hit a wall. even with vcore set to 1.4+ I cant get past 4.5.

Another problem I'm having is tightening my RAM, I cant even change the command rate with out my PC failing to boot.

I hope I've posted enough info.... for now any way

Thanks
 
Hi 8Pack Thanks for the reply. When I run aida 64 for about 30 minutes, my temps dont go higher than 70-73 degrees, and in gaming im lucky if it reaches 68. I use Coolermaster Nepton 140XL. What should I lower the VCCIO and VTT to? 1v? And my pc seems to refuse to boot if i use anything higher than 100 Strap?

Also from your guide are all of the settings in the DIGI+ page in BIOS needed?

and does my voltage +0.040 seem ok to you?
 
Ok I will try this now, is this with the same voltages as I already have. and all the Digi+ Settings.

LLC High

140%

Rest on optimized/regular and 120%

??
 
Ok when i change my BLCK to 125, 128 or 129, my pc refuses to boot. I put my ram speed to the closest one below 1833mhz with same voltage and same timings as XMP sets.

Any reason for this, or anything else I need to change?
 
Yep, computer refused to boot same as before, with monitor not even recognising that the computer is booting there for going into idle mode and just flashing.
 
You must log in or register to reply here.
Back
Top Bottom