installed 2 6950s in crossfire today, but i cant run any 3d apps, been trying to run the heaven benchmark but i get the BSOD with the message (after it loads i hear sound for a few seconds then heaven crashes then the system bsods)
Attempt to Reset Display Driver and Recover from Timeout Failed BSOD
Ive tried using driver sweeper in safe mode but nothing is helping, also i noticed that i was only using one crossfire link so quickly put the other in, any other suggestions? Its definantly just 2 6 pin connectors per card for power? They have little 2 pin ones coming off the 6pin one too but that doesnt seem to go anywhere.
This was prebuilt from ocuk and was kind of hoping to avoid this problems by going prebuilt instead of builind my own Do they not test the systems before sending out?
screenie of settings:
If i click identify gpu it comes up with 1.
Attempt to Reset Display Driver and Recover from Timeout Failed BSOD
Ive tried using driver sweeper in safe mode but nothing is helping, also i noticed that i was only using one crossfire link so quickly put the other in, any other suggestions? Its definantly just 2 6 pin connectors per card for power? They have little 2 pin ones coming off the 6pin one too but that doesnt seem to go anywhere.
This was prebuilt from ocuk and was kind of hoping to avoid this problems by going prebuilt instead of builind my own Do they not test the systems before sending out?
screenie of settings:
If i click identify gpu it comes up with 1.
Last edited: