Please remember that any mention of competitors, hinting at competitors or offering to provide details of competitors will result in an account suspension. The full rules can be found under the 'Terms and Rules' link in the bottom right corner of your screen. Just don't mention competitors in any way, shape or form and you'll be OK.
If you sand down the bit where the screws fit, it'll lower the overall height by 1mm and should just about allow it to fit without bending/cutting anything.
It should also let you use thinner thermal tape (1.5mm).
Fwiw, the Enzotech copper heatsinks that Matt used were 14mm tall and just scraped the main heatsink.
The Gelid is 14mm tall before you sand down the end bits. This means it should fit if you get rid of those bits.
My pic here shows it fitted without the end bits removed and look how tall the Enzo sink is when just standing on the bare pcb.
When are you going to come play some Dirt Pete and stop playing hard to get ? Afraid young Matt and Old Tommy/Scotty will show you a lesson?
I beat you in some of the races last night young Matt.
Only because i let you old timer.
When are you going to come play some Dirt Pete and stop playing hard to get ? Afraid young Matt and Old Tommy/Scotty will show you a lesson?
Sorry mate, I've had the pc half in bits while I'm sorting out the loop stuff.
I'm posting on the phone right now.
Aside from that, I've only had less than an hour on this horrible game since I got it
Am I gonna need to upgrade the crap out of the cars to get a fighting chance?
)
If it is the same stuff as Matt and myself have been using, I call pebcak
If it's G1, then fair enough
Just use some Akasa tape mate. Far less messy.
