Abit IP35 Pro overclocking guide needed

[Datamonkey]

Hey guys,

Received my

Abit IP35 Pro
q6600 Go
4gb of OCZ plat. 6400 rev 2

This is all water cooled.

Im looking for some guidence from others who have this board on what settings to set voltages to in the bios.

Im looking to get 3.6ghz stable. I have been running mem test for the last 3 hours with the mem at 960mhz which it has passed fine.


Any advice would be appreciated.

Cheers

 

[djay]

I got pretty much the same setup as you except i have 5300 Ballistix ram running at 1000mhz.

I'm using 1.4825vcore in the bios for the cpu.
400mhz FSB
DDR Voltage ive set to 2.2v
The rest of the voltages i have upped by one notch in the bios.

Mine is running 3.6ghz stable. I have also enable C1e and eist in the bios so the cpu drops to 2.4ghz when not under load.

The only issue i had was running Cpuz 1.41 and the Uguru software side by side whent he system was under load, caused it to lockup and reboot etc.

 

[easyrider]

http://forums.overclockers.co.uk/showthread.php?t=17739133