Right. I have a decent system as per sig. However, it is all installed in a Fractal Torrent Full Tower Case. Brilliant case, fantastic airflow. No issues.
However. It is massive and I am redesigning my living room at the moment to a be a bit more modest. I was thinking of moving the components into a smaller case but I have a 360 AIO for the CPU and the 3090FE isn't exactly small.
Moving to a smaller case will require new CPU cooler, new PSU as mine is ATX so SFX will be required for a notable reduction, plus the case itself.
This lead me onto an idea. I need a side/coffee table for the new layout. What if I found a decent sized coffee table on marketplace that essentially has a 'box top' that fits the measurements of the 3090 height wise and just make the required cuts/holes, adding mesh where needed for airflow. Paint the coffee table and boom. PC in a subtle box.
Has anyone attempted anything like this? Aside from measuring accurately for motherboard screws, then PSU, fans etc it seems not too difficult?
Any opinions appreciated. Worst case if I get a cheap £20 coffee table with the required size. Drill the holes etc and it just doesn't work not much effort wasted aside from time but leaning towards am pretty sure I can make it workable?
However. It is massive and I am redesigning my living room at the moment to a be a bit more modest. I was thinking of moving the components into a smaller case but I have a 360 AIO for the CPU and the 3090FE isn't exactly small.
Moving to a smaller case will require new CPU cooler, new PSU as mine is ATX so SFX will be required for a notable reduction, plus the case itself.
This lead me onto an idea. I need a side/coffee table for the new layout. What if I found a decent sized coffee table on marketplace that essentially has a 'box top' that fits the measurements of the 3090 height wise and just make the required cuts/holes, adding mesh where needed for airflow. Paint the coffee table and boom. PC in a subtle box.
Has anyone attempted anything like this? Aside from measuring accurately for motherboard screws, then PSU, fans etc it seems not too difficult?
Any opinions appreciated. Worst case if I get a cheap £20 coffee table with the required size. Drill the holes etc and it just doesn't work not much effort wasted aside from time but leaning towards am pretty sure I can make it workable?
