Adding a Drain Line to Exciting Loop

Avathar77 · 28 Jun 2011 at 01:45

So this is my current loop now
Res/Pump-> CPU block -> Top RAD -> GPU block -> Front RAD -> Res/Pump

[/url] Current Setup by Avathar77, on Flickr[/IMG]

I was thinking of adding a Drain line for the convenience, Using a "Y fitting" bitween the Res/Pump and CPU Block, and having a Ball valve at the end.

[/url] Current Setup With Drain line by Avathar77, on Flickr[/IMG]

Would this be ok?
Will it effect the pressure or performance of the loop?

Avathar77 · 28 Jun 2011 at 10:31

Vinni3 @H|H said:
What about a QDC? (quick disconnect)

I have 2 sets of QDCs connected to the GPU as I may remove the GPU more often.
Are you saying I can use QDCs to make the loop drain?

Avathar77 · 28 Jun 2011 at 10:32

koooowweeee said:
It will not affect the loop flow.

But you need to turn the fans round on your rad

Which RAD? Top or the bottom? I am guessing Top? Is it because fans are pushing "hot" air through the Top RAD?

Avathar77 · 28 Jun 2011 at 11:14

Reason for not doing the top rads like that is because I dont have dust filters for the big boy fan. I have to clean the front dust filters every 3-4 weeks!
How ever I might just try it

Currently my Highest CPU temp is 28 Idle and below 50 @ load(with P95/IBT/gaming in BFBC2) and GPU temp is 30C Idle and never goes above 40C @ full load(furmark/BFBC2) all this while room temp is around 23C
All RAD fans running around 900RPM.

But this is not the case since yesterday

My room temp alone is 28C and CPU idle is 36C! GPU idle is 37C.
Haven't tried gaming yet :eek: