Soldato
- Joined
- 19 Oct 2006
- Posts
- 3,708
Our work ADSL connection has been dropping sync for the past three weeks (seems to drop under load) here are the line stats
SNR Down 0.1
SNR Up 6.3
Line Atn Down 30.1
Line Atn Up 16.3
Rate Down 15795 kbps
Rate Up 1147 kbps
Max Down 18112 kbps
Max Up 1156 kbps
CRC Down 0
CRC Up 65504 (I guess this is the max value as it does not go above this)
Previously the line has always synced around 12mbps but we have changed the router faceplate cables etc to try and resolve the issue. (interestingly on samknows and bt website the estimated speed now shows as 6mbps for our line where as it always used to show 12mbps)
We are 1.58km straight line from the exchange.
All BT are saying is we have some equipment effecting the line causing a high number of upstream HEC errors.
Nothing has changed our end and has been working ok for the last 2 years (it was a new line when it went in, socket is right next to the cabinet), a BT engineer came and fitted a new filtered faceplate and an RF3 filter in case of interference. It is generally ok first thing but after about an hour and a half it seems to start dropping out and gets to the point where it is down every 15 mins.
We were using a Cisco SA520W with Netgear DM111P ADSL modem on WAN1 but when the trouble started we swapped the DM111P out with a TP-Link TD-W8961ND configured in bridge mode on WAN1 of the SA520W with the same results. At the moment I am going to turn off the SA520W and let the TP-Link do the routing for the time being just to make sure its not the SA520W but to be honest the SA520W always stays up when the ADSL sync goes off.
Any ideas chaps? Help would be very much appreciated.
SNR Down 0.1
SNR Up 6.3
Line Atn Down 30.1
Line Atn Up 16.3
Rate Down 15795 kbps
Rate Up 1147 kbps
Max Down 18112 kbps
Max Up 1156 kbps
CRC Down 0
CRC Up 65504 (I guess this is the max value as it does not go above this)
Previously the line has always synced around 12mbps but we have changed the router faceplate cables etc to try and resolve the issue. (interestingly on samknows and bt website the estimated speed now shows as 6mbps for our line where as it always used to show 12mbps)
We are 1.58km straight line from the exchange.
All BT are saying is we have some equipment effecting the line causing a high number of upstream HEC errors.
Nothing has changed our end and has been working ok for the last 2 years (it was a new line when it went in, socket is right next to the cabinet), a BT engineer came and fitted a new filtered faceplate and an RF3 filter in case of interference. It is generally ok first thing but after about an hour and a half it seems to start dropping out and gets to the point where it is down every 15 mins.
We were using a Cisco SA520W with Netgear DM111P ADSL modem on WAN1 but when the trouble started we swapped the DM111P out with a TP-Link TD-W8961ND configured in bridge mode on WAN1 of the SA520W with the same results. At the moment I am going to turn off the SA520W and let the TP-Link do the routing for the time being just to make sure its not the SA520W but to be honest the SA520W always stays up when the ADSL sync goes off.
Any ideas chaps? Help would be very much appreciated.