advice or suggestions please

Uncle Petey · 18 Apr 2014 at 15:43

robertchalmers1 · 18 Apr 2014 at 15:52

that one petey looks a bit better just need to work out how many 90 bends i need see if i have enough before i break it all down

robertchalmers1 · 18 Apr 2014 at 15:53

best part the res can sit on the shroud as well keep cables outta sight. just out of interest woud you have it so the in and out ports are facing forward

Uncle Petey · 18 Apr 2014 at 16:07

It would make routing the tubing easier and it looks like you've cut the 5.25 cage thing, so there's no bottom section to block anything.

robertchalmers1 · 18 Apr 2014 at 16:57

yeah cutting it out was the very 1st thing i done save any hassle further down the line, not sure if i will manage to strip it down tonight but will defo need to do it tomorro and update the build log

ukbilleh · 18 Apr 2014 at 21:47

robertchalmers1 said:
yeah cutting it out was the very 1st thing i done save any hassle further down the line, not sure if i will manage to strip it down tonight but will defo need to do it tomorro and update the build log

do you even use the cage for anything like fan controllers etc? why not just drill it out. May give your case a more open and clean look. Will also give a better view of that front rad

robertchalmers1 · 19 Apr 2014 at 10:03

ukbilleh said:
do you even use the cage for anything like fan controllers etc? why not just drill it out. May give your case a more open and clean look. Will also give a better view of that front rad

i have temp sensor and fan controller in there plus a hot swap for a 3.5"hdd. i wouldnt drill rest out as it feels flimsy as just now with the bottom section took away