Aerocool Aero One case with 6 pin Eclipse fans & hub ARGB NOT WORKING HELP

[Dan Ilott]

Good afternoon guys,

I have recently built my first PC and for the most part it went swimmingly. But i have a strange issue which is bugging the hell out of me. My fans (6 pin proprietary connectors) run fine and i am able to control fan speeds etc. But the RGB is not allowing me to control it through the ARGB header on my MoBo. It will however go through presets when connected to the reset button. I have tried everything myself and google can think of but no luck. Also another weird thing is that when i remove the ARGB plug from the MoBo the RGB fan lights stay on.

The connector hub most closely resembles the Aerocool H66F hub. Looks identical just without the plastic shroud (looks like a PCB with connectors on).

Any help is appreciated!

 

[Dan Ilott]

Bump

 

[geekyadz]

Good afternoon guys,

I have recently built my first PC and for the most part it went swimmingly. But i have a strange issue which is bugging the hell out of me. My fans (6 pin proprietary connectors) run fine and i am able to control fan speeds etc. But the RGB is not allowing me to control it through the ARGB header on my MoBo. It will however go through presets when connected to the reset button. I have tried everything myself and google can think of but no luck. Also another weird thing is that when i remove the ARGB plug from the MoBo the RGB fan lights stay on.

The connector hub most closely resembles the Aerocool H66F hub. Looks identical just without the plastic shroud (looks like a PCB with connectors on).

Any help is appreciated!

After reading the manual, I have found that the hub is H66C (not H66F as you state).

Pressing and holding the reset button for 3 seconds will switch to using the mobo ARGB input (basically, the software that you use to control your motherboards ARGB (you don't state what mobo it is so I can't help you with that)).

This was done with a 5 minute search of your case.