AfterBurner fan curve queery!

[Zeebedy]

Hey guys,

I currently use a custom fan curve on MSI AB for my 2070S. I have the fans kicking in at 50c, but in CS GO the GPU is really underworked and therefore, the temps go a bit over 50c and the fans kick in, then back down below 50c and they stop, then the cycle starts over..

Can I set the curve to kick in around 60c to stop them kicking in and dropping all the time?

Or is that too high / unsafe?


Cheers.

 

[Zeebedy]

Thanks guys.

I cap out around 70c gaming load with my curve.

just wanted to change the curve in the lower end.


Cheers.

 

[Zeebedy]

Perfect mate.

 

[Zeebedy]

I have mine like this (EVGA GTX 1080Ti)

Kicks in when needed and ramps up, not going above 75c. You want to keep it below 75 or the card will probably start clocking down.

Thanks for the graph mate.

What is your idle and load temps with that fan curve?

 

[Zeebedy]

It is absolutely fine Just a friendly reminder, if you have more than one fan control software in your system, it may create unwanted behavior for your custom fan curve.

Thanks for the advise, I currently run only AB, for me it is the best control software.