Air bubbles

rabc1690 · 4 Mar 2013 at 11:20

Hello

i have an air bubble approx 1" long in the lowest section of my loop and for the life of me i cant get it to budge, does anyone have any ideas or advice on how to remove it please

rabc1690 · 4 Mar 2013 at 11:26

ive been rocking the case all morning but no luck just wont budge and i dont have the option to increase pump speed the one i have is the xspc all in one 240mm kit.

i wondered why my gpu temp was so high now i know why

rabc1690 · 4 Mar 2013 at 16:16

tghink i managed to work it out but the GPU still sitting at 52c under load still seems a bit high to me

rabc1690 · 4 Mar 2013 at 17:19

i have a 240mm fan that came with the xspc kit and a 120mm the ek rad that im pretty sur is 47mm thick. was advised that would be enough to run an 8350 and a 7970

rabc1690 · 4 Mar 2013 at 17:19

i mean 240mm rad

rabc1690 · 4 Mar 2013 at 17:45

thats colling both cpu and gpu

rabc1690 · 4 Mar 2013 at 17:55

cpu sitting a modest 4400 at 1.400 gpu at 1100 and 1500 stockvolts. so nothin too far that way. so cant figure out why gpu hitting mid 50s. to stress i use intel bun test and valley/heaven for gpu

rabc1690 · 4 Mar 2013 at 18:00

nothing i do can get it stable under those volts. also for everyday use gaming etc is there any need for a big oc.

rabc1690 · 4 Mar 2013 at 18:33

its an 8350 i have. was lead to believe i needed to oc the pants off it or i would be cpu bottlenecked

rabc1690 · 4 Mar 2013 at 18:34

also i can get it to 5 ghz but volts needa be 1.51 and temps sneak upto 63 so dropped it back down. run at 4.4 as i only have a 700w psu

rabc1690 · 5 Mar 2013 at 09:00

its a full cover block and that seemed to be where the air bubbles were. just after gpu outlet

rabc1690 · 5 Mar 2013 at 09:42

my chip def wont run 4.4 any less and thats with llc at ultra high i dont know how so many can get theres that high with such low volts, even 4.8 bi have to have 1.49v. would love to have it that high with lower volts. what board do u have

rabc1690 · 5 Mar 2013 at 09:58

BaDBoY_uK said:
[email protected] is very high. I run 4.8Ghz at 1.375V

did you use the multi only to oc???

rabc1690 · 5 Mar 2013 at 13:21

nkata said:
4.7Ghz at 1.375 on an AMD FX8350. Needs a nudge up to 1.4V for priming but for gaming and encoding, rendering tasks runs fine on 1.375V.

i dont understand how you can run that low volts for 4.7. even talking to guys on ROG etc who cool with LN2??? all say im going to need at least 1.46 upwards and a minimum of 1.49 for a 4.9 oc fully stable.

what mobo do you have and at what settings