I have a problem where when I start my system the multi is at x7 when I start LinX it jumps to x20 when LinX start to stress the cpu it drops to x15. I have gone into bios and turned everthing off that should control the multi but it still dose it. is there any other reason it may be happening othere than a bios setting.
-
Competitor rules
Please remember that any mention of competitors, hinting at competitors or offering to provide details of competitors will result in an account suspension. The full rules can be found under the 'Terms and Rules' link in the bottom right corner of your screen. Just don't mention competitors in any way, shape or form and you'll be OK.
AMD FX-6100 multiplier problems
- Thread starter Dave0w
- Start date
just done that restarted and still the same
It sounds normal to me x7 is the idle mode (Cool and Quiet), x20 the maximum speed offered by turbo boost when only a few cores are used, then you run Linx which loads all cores and so turbo boost lowers the clockspeed further.
Although, looking at OCUK specs the correct multipliers should be x7, x16.5 and x19.5 for a FX6100... do you have the latest bios for your motherboard?
Although, looking at OCUK specs the correct multipliers should be x7, x16.5 and x19.5 for a FX6100... do you have the latest bios for your motherboard?
I dont know its my bros system its about 3 weeks old.
the stock clock is 3300mhz boost is 3900mhz. when I run it under load it drops to 3000mhz. if I run LinX in singal thread it still dose it. some times it even hits 2700mhz
the stock clock is 3300mhz boost is 3900mhz. when I run it under load it drops to 3000mhz. if I run LinX in singal thread it still dose it. some times it even hits 2700mhz
.
Soldato
- Joined
- 19 Jul 2007
- Posts
- 3,131
- Location
- notts , uk
turned cool'n'quiet off in bios as well as c1e support ? , it should stop the down clocking then