Antec 300 help

Soldato
Joined
28 Dec 2009
Posts
6,888
Location
Wales
Right,

Just recased my pc into the 300 and infairness it is an awesome case! Also installation of the baram heatsink also went well, though I'm unsure if I used enough AS5.

Anyway the two fans that come with the antec 300 appear to use molex connectors, however my psu a corsair TX650 does not have the right type of molex connector??

I need some help as to how I now power the fans?
 
1. Get rid of the stock fans, they're not amazing
2. They use the same power connector as an IDE hard drive does, I'm sure the TX650 has one of them...
 
Err, they're a standard molex connector, male one side female the other

The molex connectors are the same as the ones on my psu so they won't connect. They are botht he type without pins. Shall take another look as may be being stupid. May replace the back case fan as well but would've been nice to get them working
 
The molex connectors are the same as the ones on my psu so they won't connect. They are botht he type without pins. Shall take another look as may be being stupid. May replace the back case fan as well but would've been nice to get them working

The PSU molex have no pins???

The fan molex connectors will only have 2 pins in them iirc, they plug into a big 4 pin molex.
 
Back
Top Bottom