Antec C8 - 420MM AIO

ZXSpectrum

ZXSpectrum

ZXSpectrum

Soldato
Joined
20 Oct 2002
Posts
11,681
Location
Derby
Has anyone tried this? The top of the case states it can fit 3x140MM fans but only a 360MM rad is supported, i believe this is because of the different sizes in end tanks/fittings on rads.. The P20CE says the same support at the front but i manage to fit a 420MM Arctic Freezer 3 AIO at the front "just".

Any help would be appreciated. If anyone has the case could you please measure the distance internally from front to back at the top of the chassis? :)
 
Well after looking at the specs/measurements of both the case and the aio i do believe it will fit... i will update when i get it ordered and will get some pics up. I might have to put the fans between the case and the Rad to give a little clearance for the clips that hold the front panel on but hopefully doable.
 
I havnt tried it yet but I do plan to in the future. 38mm for the rad and 25mm for the fans should be fine above the motherboard it’s just the length. It says it can fit 3x140mm fans at the top and from what I can see there should be a little more room that hopefully should allow for the end tanks of the rad.
 
According to the technical information its 458mm long so 40mm longer than the 3x140mm fans so i would give an extra 10mm on top for wiggle room but depends on how much room is available. I have managed to fit a 420 in the front of a P20CE which states it will only fit a 360mm Rad and 3x140mm fans.

Unfortunately without the technical drawing of the C8 chassis or one at hand i cant 100% say if it will or not.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom