Antec P160 Display Problem

kiltman67

kiltman67

kiltman67

Associate
Joined
2 Aug 2006
Posts
63
This problem may turn out to not actually be the case but I can't work out where else it would come from and it's on the case where it's manifested so I thought I'd post here.

Over the past few days I've been setting up my new system and for the first day the Thermometer display worked fine. Then today it began alternating originally between -E and the temperature and after 00 and the temperature. For those who don't know it should alternate between the temperature on the two probes. The problem seemed to begin around the time I installed a Firewire and USB external hard drive, but can't work out how there could be a link.

Any ideas?
 
kiltman67 said:
This problem may turn out to not actually be the case but I can't work out where else it would come from and it's on the case where it's manifested so I thought I'd post here.

Over the past few days I've been setting up my new system and for the first day the Thermometer display worked fine. Then today it began alternating originally between -E and the temperature and after 00 and the temperature. For those who don't know it should alternate between the temperature on the two probes. The problem seemed to begin around the time I installed a Firewire and USB external hard drive, but can't work out how there could be a link.

Any ideas?
Click to expand...

Have you checked for conflicts in windows?
 
kiltman67 said:
I just rotated the display panel down 45 degrees and everything went back to normal. Perhaps it's wiring.
Click to expand...

That would've been my second hunch :)

I hope it doesn't cause you anymore problems :)
 
You must log in or register to reply here.
Back
Top Bottom