Antec P50 Case - coming soon.

Ace Modder

Ace Modder

Ace Modder

Soldato
Joined
8 Sep 2003
Posts
23,238
Location
Was 150 yds from OCUK - now 0.5 mile; they moved
Looking at £50 inc VAT.

* Dual Chamber - motherboard on one side, PSU and HDDs behind the motherboard tray in a seperate chamber.
* 240mm rad in the front, 240mm rad in the top!!!!










 
Hello,

Just wondering if you could answer a couple of questions:


  1. What are the dimensions of the case?
  2. Given the top panel is removable is there any chance Antec will make a solid unventilated panel?

Thanks,
 
Would the Palit Super jet stream 980 fit in this?

I was going to get a Fractal Arc Mini r2 (why don't you sell this?) but this Antec looks nice.
 
I will do, but will be about 3 weeks before I get one myself. First production run is scheduled for this week, so 2 weeks for manufacturing, then air shipment to Europe so about 3 weeks.
 
Ace Modder said:
Just check that palit cards is 280mm. The P50 takes up to 300mm cards :)
Click to expand...

Thanks, its not so much the length Ive been struggling with (;))

It's the height, their site lists it as: PCB Width 280mm x 133mm

It's whether or not I'll be able to get the side panels on with the cables all plugged in, I'll measure it at some point and see how much clearance I need for definite as I'm not sure what they mean by 'PCB' in that measurement.
 
ah, my suggestion to you is look at CPU cooler height on cases, I assume GPU will be the same, we suggest max CPU cooler height is 130mm, your card is 133mm...

It depends on where it is measured from, base of card which sits in a port or from the top of the slot, which is above the port.

CPU sockets are raised, so the palit card may fit if the 130mm is from the base of the card, as the base of the card will sit around 5-8mm below the base of where a CUP cooler sits (hope this makes sense)

But I'm not making any promises :)
 
Don't like how the roof at the front is higher then the rest of the roof.... flatten it all out please.

Apart from that looks like a nice little case.

Infact also get shot of the front panel USB and audio connectors, they look minging exposed like that.

The Lian-Li Q25 is such a beautiful little case as it has no front panel connections to ruin the smooth lines of the case.
 
Ace Modder said:
ah, my suggestion to you is look at CPU cooler height on cases, I assume GPU will be the same, we suggest max CPU cooler height is 130mm, your card is 133mm...

It depends on where it is measured from, base of card which sits in a port or from the top of the slot, which is above the port.

CPU sockets are raised, so the palit card may fit if the 130mm is from the base of the card, as the base of the card will sit around 5-8mm below the base of where a CUP cooler sits (hope this makes sense)

But I'm not making any promises :)
Click to expand...

Sounds like it would be very tight, especially with cables plugged in as these go in the top.

Thanks for your help though!
 
You must log in or register to reply here.
Back
Top Bottom