I'm building a custom LED thingy for under the seat of my scooter, and it's been about a billion years since I dabbled in electronics so I just need a bit of a sense check if anyone's able please!
What's a good quality 18650 battery, and what's a good seller? I've heard far too many negative things about fake batteries and whatnot.
I'll be charging it with this:
I'll be adding a little push-button switch to turn the light on, and it'll turn off automatically. For this I intend to use this:
I've not yet decided on an LED, need to research them still. However, can I wire directly to that PCB, or do I need a relay / driver for the LED?
I guess this depends on what LED I use, but any advice would be greatly appreciated. The most important aspect here is quality, reliability and compactness. I'll be 3D printing the housing as well so it's very flexible in terms of dimensions and shape.
Anythnig wrong with what I've posted here?
Cheers
What's a good quality 18650 battery, and what's a good seller? I've heard far too many negative things about fake batteries and whatnot.
I'll be charging it with this:
5pcs 5V 1A USB Type C 18650 TP4056 Lithium Battery Charger Module Charging Board | eBay
5PCS X 1A TP4056 lithium battery charging module. Current: 1A adjustable. It is better that the charging current is 37% of the battery capacity. Input interface: MICRO.
www.ebay.co.uk
I'll be adding a little push-button switch to turn the light on, and it'll turn off automatically. For this I intend to use this:
10s~24h Programmable Timer Control Switch Module Timing 3.3V-18V UK Stock | eBay
Can drive the 3V relay, 5V relay, 12V relay, LED lamp etc.;. Timing accuracy is higher than the ordinary 555 timing, timing simulation of analog circuits. Module working current is less than 1mA. Can choose low input, high input, low output, high output, through the short-circuit points;.
www.ebay.co.uk
I've not yet decided on an LED, need to research them still. However, can I wire directly to that PCB, or do I need a relay / driver for the LED?
I guess this depends on what LED I use, but any advice would be greatly appreciated. The most important aspect here is quality, reliability and compactness. I'll be 3D printing the housing as well so it's very flexible in terms of dimensions and shape.
Anythnig wrong with what I've posted here?
Cheers