Anyone fitted the LGA1700 bracket to Arctic Liquid Freezer 2 recently?

[BillHicksRIP]

I'm trying to install a Liquid Freezer II 360 A-RGB Rev 1 on a Z690-P Wifi D4 motherboard & I5-12600K and the LGA 1700 kit I got from Arctic should have included "x2 screws for Mounting Clips" but I haven't got them. Did anyone else receive these? There are 4x AMD Socket AM4 screws in the box but I'm not sure they're the same.

 

[BillHicksRIP]

Thanks for the replies. I only got 4 screws with the cooler kit but the documentation implies you should get 4 AMD ones and 2 other ones, unless I'm completely misunderstanding it. They do look similar in the picture but I did try with a couple of the 4 and they were impossible to put in and couldn't get close to screwing them in tight, so bailed. The docs say to ensure to use the correct screws which should go in easy but that wasn't the case. Can you remember if you got a pack of 4 and a pack of 2? Thanks.

 

[BillHicksRIP]

It's these screws that attach the brackets to the cooler. If you click on the image it's showing x2 screws for mounting clips which are the ones I don't have.

 

[BillHicksRIP]

That's where I'm confused. I can't attach the mounting clips to the block as I don't think I have the 2 screws. I've got 4 screws, 2 of which fit in the hole of the mounting clip but they don't screw into the block. I fully expect I'm doing something dumb here so appreciate the help.

 

[BillHicksRIP]

As expected, I was doing something dumb. Found the 2 screws in one of the bags. Note the subtle difference although it's easy to miss. Thanks for the help!

 

[BillHicksRIP]

@Vimes One last thing I'm struggling with is do you connect the power to the CPU_FAN header or the AIO_PUMP header? I've got it attached to the AIO_PUMP header currently but the fans attached to the radiator are running at 100%.

 

[BillHicksRIP]

Thank you!