Anyone have experience with Air Flow in an AVP Hyperion EV33B case?

[ExoMale]

so ive rebuilt my system in the case and to do the finishing touches i am sorting out case fans, but because of the design im wondering the best way to go about the air flow if anyone has used this case?#

so far i have:

120mm in the front(main components chamber) as an intake, i will add a 2nd soon
120mm side panel of main chamber as an exhaust
92mm rear of main chamber as an intake

i have 2 80mm fans to fit in the other chamber, but because its where the drives and psu goes i am debating which flow i should have the fans for which is where the question comes from and unless i get a slim 120mm then the vent opposite the psu will be left clear.

 

[ExoMale]

Are you finding your drives or PSU get warm? Just adding noise really, unless you have a thermal issue.

I found that case worked quite nicely with a single case fan but I didn't put particularly high performance parts in - just an i5-3330 and GTX 970 for my nephew.

thanks for reply.

nope i dont find any issues with with heat or noise, i dont use my computer long enough to care, but when i get a case with multiple fan options i do like to make a cool system. the 2 120mm fans are rgb ones from the CiT raider case which are quiet which will also be the 3rd 120mm ill be fitting, the other fans are Noctua grey models - 92mm NF-B9 Redux 1600, 2x80mm NF R8 Redux 1800. the 92 is fitted and works quietly, so id imagine the 80s will do the same.

because of the chamber with the drives and psu not really needing heat dispensing i was thinking to have both as an intake, but because of the design i am thinking that be too much pressure build up? i like near quiet and cool pcs and never used this sorta case before.