Soldato
After setting up my ender 3 v2 and doing a couple of small prints which came out great i decided to try a webcam stand.
Its printed well and the outside of the print is spotless, the top of the base though is very good apart from the very edges on the corner on the left hand side which you can see here
The right hand side is perfect
Its like its dragged abit on the corner when doing the very last layer on that part of the print
Apart from that its a perfect print.
Just wondered if this is normal or is something not quite setup 100% ??
I know its only very minor but just wanted to ask
Its printed well and the outside of the print is spotless, the top of the base though is very good apart from the very edges on the corner on the left hand side which you can see here
The right hand side is perfect
Its like its dragged abit on the corner when doing the very last layer on that part of the print
Apart from that its a perfect print.
Just wondered if this is normal or is something not quite setup 100% ??
I know its only very minor but just wanted to ask
Last edited: