I have just reapplied 2 times each my tuniq tower using the line method
and spread method i have to say i'm getting the exact same temps
i followed the official instructions for AS5 line in middle twist 1 degree.
Doesn't seem to make a blind bit of difference which method is used
from what i have found.Mind you it's almost impossible to keep the tuniq still
whilst seating and turning the screws.
and spread method i have to say i'm getting the exact same temps
i followed the official instructions for AS5 line in middle twist 1 degree.
Doesn't seem to make a blind bit of difference which method is used
from what i have found.Mind you it's almost impossible to keep the tuniq still
whilst seating and turning the screws.
Last edited: