ARGB/PWM cable

cosmogenesis · Tuesday at 17:43

I have a case that comes with a hub. The hub contains a ARGB/PWM cable with two connectors off of it. Would I need to connect both of them to the motherboard?

cosmogenesis · Tuesday at 18:11

It also has a 4 pin to SATA port but the cable was not supplied so it’s somewhat confusing as I feel that the hub needs power. I can’t find the 4 pin to SATA cable anywhere or online to buy one
In this review http://gamersnexus.net/cases/surpri...b-case-review-thermals-cable-management-noise

It’s shown in the peck in the box but mine was empty

cosmogenesis · Tuesday at 18:35

I’ve messaged the vendor who sold me the case and antec too see what’s actually included. Very strange.

The ARGB/PWM cable is already installed but this one controls the fans led and fan speed ?

cosmogenesis · Tuesday at 19:16

Yes the instructions are non existent on the matter.

cosmogenesis · 2024-10-30T09:29:10+0000

https://1drv.ms/i/s!Ar2VNLOdjBMuo7hmoQy6nnyQwC-FIA?e=KkbChx

anyone recognise the cable in this picture (SATA one). I need to get one

cosmogenesis · 2024-10-30T13:34:37+0000

Thank You.

cosmogenesis · 2024-10-30T17:57:28+0000

It’s all ok - I’ve found it.

cosmogenesis · 2024-10-31T11:24:46+0000

Yes the cable has been located. Just trying to work out the other bit - ARGB/PWM cable has two connectors and I need to connect both (manual simply says connect them).

So I am presuming to connect the ARGB cable to an addressable rgb port on the motherboard and the pwm one to a fan header on the motherboard.

There’s an aura rgb port on the motherboard too - nightmare really

Crazy naming conventions