Assembling a Parvum Case

a66as · 19 Nov 2013 at 12:46

I recently assembled my own parvum case but the sides (where the two sides meet) aren't aligned 100%. either side is sticking out slightly does this mean I miss-aligned the cube things or is this normal? some parvum owners enlighten me

a66as · 19 Nov 2013 at 20:50

I dismantled it and going to have another go at it, do you guys know where i can find a detailed assembly guide?

a66as · 20 Nov 2013 at 21:39

Hey guys, i managed to upload a picture. The problem only seems to be with that one side all the rest are aligned fine

What can i do to fix this problem?

a66as · 22 Nov 2013 at 22:46

After a bit of twiddling It became slightly more aligned, then I thought meh I'll just live with it you can hardly tell anyway. Should have my build finished by tomorrow I'll post some pics in the build log

a66as · 24 Nov 2013 at 00:15

Assembled the case and put all my components in, case looks stunning but my front cover is still misaligned (I'll contact parvum about this) and my switch button isn't working (which may well be my fault)

On my switch the led is lighting up but it won't power the system up, so I have to keep clicking the on button on mobo which would be fine if I didn't have to keep nudging my sound card and use a pen to reach it

. I soldered the black wire near - and the red wire near +. And on the mobo I put the red/black wire on power / ground. Which one of these did I get wrong

a66as · 24 Nov 2013 at 00:27

Damn I have them the opposite

a66as · 24 Nov 2013 at 11:24

Yeah I'm going to try that next

just need to pop over to asda first and buy a wireless adapter. Thought the gene had 1 built in

a66as · 25 Nov 2013 at 11:45

I got the led switch working, but one last thing concerning me about the case is the back panel (that little panel where you screw on the gfx card) wont properly align and my graphics card wont slot into the Mobo fully, it still works but it is slightly out from one end and it is pretty noticeable.