Asus P5N32-E SLI and memory voltage

Flanno · 27 May 2007 at 02:15

Anyone know if this board boots with OCZ Reaper 9200 memory.
Or does the memory have to be able support 1.8v. I know the reaper does boot with 1.95 ok.

Flanno · 27 May 2007 at 21:46

Bump.

Anyone ?

Rroff · 28 May 2007 at 00:19

I don't know if it boots with the reaper modules or not - tho I know some people are running them with it... however the default voltage for 1.8v is quite high - 1.87 or so - so a good chance they will boot on default.

Bomag · 28 May 2007 at 01:26

I got some last week from OcK. It booted fine with mem voltage set to auto.

Its more stable at higher speeds than my corsair 8500c5 but I cannot get it over 1066mhz (probably the mb).

Flanno · 28 May 2007 at 01:53

That's great stuff guys. Thanks.

I have 4gigs of the 9200 stuff coming which I know is good for 1142mhz if you use the EPP profile according to OCZ.

Question is whether the Asus mobo will let me run 4 sticks faster then 667mhz or 4 sticks at all. I know the EVGA board will but RMA'd mine when it turned out to be a Rev AR and dead even though I specifically ordered an A1. Sucks. Asus was the next best thing for SLI. Will probably sell it and get an A1 when OcUK get them in though.

Bomag · 28 May 2007 at 14:15

I doubt that you would get 4Gb up to 1142Mhz, the clocking guarantee is for two Dimms only. The fastest setting for me is 840mhz 4-4-4-12 1T