AV Switch wiring help please!!

[pgi947]

Afternoon everyone,

I've just had a massive brain trump and I can't remember how I wire up my Dimastech anti-vandal switches.

I can't see any documentation to suggest whats what.

Have 5 pins on the actual switch, 1 x 12v, 2 x 'ON', 1 x square/round edge box and one un-marked.

And on the cables I have 2 x Yellow (?) 1 x red (12v?) & 1 x black (gnd?), both yellows terminate to the same block (2pin) and the red and black each terminate to their own single pin block for the FP headers.

 

[pgi947]

A little digging, its not 2 x 'ON' & box thing is infact a 'C' its:

1 x NC - Normally Closed
1 x NO - Normally Open
1 x C - Common (Ground)

And the two outer pins are +/-

Like so: http://img.techpowerup.org/101115/vandal switch wiring.jpg

So 12v/red to +
Black to Ground or -?
2 x yellow to??

Or two yellow to +/- for an LED circuit, black to ground and red to NO?

 

[pgi947]

Anyone?

Been googling my little socks off and finding very little information.

Basically I've narrowed the two yellow (12v +/-) as being for the LED, black for common and from what I can make out in both a power and reset switch they are always connected as 'Normally Open'.

Can anyone confirm/deny/hint

Edit: Now reading that red (+5v) = +, Black = - (for LED) and that then leaves the two yellows.

 

[hyperst]

Did you sort this?
If so care to share?

If not maybe this will help

I think it should be, NO and Com to the motherboard headers for powering system ON, and the led for the power switch from the motherboard header is the ones marked +/-