Barrow Digital OLED Display Flow and Temperature Sensor help needed

[chris blackford]

Hi all I have just installed the Barrow Digital OLED Display Flow and Temperature Sensor its showing temp but not flow it just says 0 any one got this item and not what I can do to fix it

 

[andy_mk3]

Need to swap the internals around as it will only read flow in one direction. If it’s the same as mine I think there’s 4 screws on each end and it comes apart.

 

[Jay85]

Need to swap the internals around as it will only read flow in one direction. If it’s the same as mine I think there’s 4 screws on each end and it comes apart.

This, you can switch the internal impeller around so it moves coolant correctly. I've done this before on a Bitspower flow meter.

 

[SpudMaster]

As above, if the flow is going from left to right as you look as the display then you need to swap the impeller around. If you've already done that and your pump is turned on then maybe you have a faulty unit

 

[chris blackford]

Need to swap the internals around as it will only read flow in one direction. If it’s the same as mine I think there’s 4 screws on each end and it comes apart.

Thanks