Bf6 optimisation questions

seanuk · 22 Nov 2025 at 18:03

Hi guys just a quick one just started playing battlefield 6 and was wondering what settings use guys use for graphics. I’m trying to research’s what is best for lower latency etc. share your settings of you like and your thoughts.

seanuk · 22 Nov 2025 at 19:33

rchads89 said:
What's your pc specs? If you struggle to see players on it like me run everything low settings

4090 and i9 14900k 32gb ddr5

seanuk · 23 Nov 2025 at 11:33

opethdisciple said:
Snip.

Snip?

seanuk · 23 Nov 2025 at 11:46

opethdisciple said:
I noticed you wanted settings for low latency.

Yes buddy I was confused what snip meant haha

seanuk · 23 Nov 2025 at 14:26

opethdisciple said:
We cant delete posts so instead we just write snip.

Does my post need deleting? Have input in wrong section? Sorry if I have buddy

seanuk · 24 Nov 2025 at 00:49

DavieJG said:
For latency, having adaptive frame settings correct and reflex active are most important. Turn graphics down to minimum required to hold a stable frame rate and don't touch frame gen with a barge pole

Appareny reflex is broken in this game atm? What’s best anti aliasing settings?

seanuk · 28 Nov 2025 at 02:26

The game just doesn’t feel snappy at all and I’m on a top end spec pc

seanuk · 1 Dec 2025 at 01:51

I get around 240fps on low settings with dlaa enabled not frame generation enabled and my frame time is around 4-5ms is this good? Game doesn’t feel the best on controller as if I have input delay or unless it’s just because I’m use to playing call of duty I suppose?

seanuk · 11 Dec 2025 at 15:46

LackyT said:
This is what I've been using with good (?) results, 1440p + specs in sig, normally 200+ FPS - Although I've still been trying to figure out why the steam FPS overlay keeps showing FrameGen (FG) at some points, when it's turned off in game

Yer my overlay was doing that also I’m sure it’s when you enable low latency reflex it does it or set a fps limiter in the menu

seanuk · 11 Dec 2025 at 17:15

Yer that’s how I noticed it that fg comes on give it a try and apparently the low latency was broken also where off was still actually enabled but I’m unsure as to weather that has been fixed or not

seanuk · 11 Dec 2025 at 18:30

Yes buddy I get roughly between 200-240fpsnon all same settings in 1440p

seanuk · 12 Dec 2025 at 04:12

Yer my system tends to sit at 200fps which seems low for my setup tbh a 14900k and a 4090 no thermal throttling I’ve checked it hwinfo

seanuk · 12 Dec 2025 at 04:52

rchads89 said:
Have you copied his config file then and imported it?

you run everything low? no frame gen or upscaling?

seanuk · 12 Dec 2025 at 10:27

markyb said:
@ 3440x1440

All on the High Pre-set, which for some reason sets to Custom.
Think the Mesh setting is set to Ultra
Capped frame rate @ [165]

Motion blur reduced down to the min
Resolution Scaling [Off]
DLSS [On]
FG [On] (2x)

Runs between 135 - 165, typically the higher end and feels very smooth.

How do you find the input latency due to running frame gen?

seanuk · 12 Dec 2025 at 13:45

markyb said:
Latency sits between 1.5 - 2.0 which is actually better than it being off if that makes sense. The stats from BF6.
It feels really nice and smooth.

Is that your actual frame time?

seanuk · 15 Dec 2025 at 01:07

markyb said:
According to the "simple" setting on stats within BF6. I feels very smooth, I tend to notice when it dips below 125fps. Alienware OLED Monitor @ 165hz.

You running any upscaling at all? Or native?