black screen and cursor

Associate
Joined
11 Mar 2009
Posts
205
Hey guys, basically ive got a pc running windows 7 64bit it was in the lounge i went to move it so i unplugged it and moved it, im not completely sure but the pc may have been in stand by mode when i unplugged the power etc.

So i then reconnected to a pc monitor it was hooked to a tv, and now when ever i turn the pc on it gives me two options run start up repair or start normally as windows did not load up properly. if i choose normal start up i get a black screen with the cursor i cannot do anything else. if i do start up repair it will eventually say it cannot fix the fault, i have tried the following to no avail any help would be appreciated as ive got a lot of uni work to be getting on with!!

so far i have:

-re seated ram and graphics card
-forced it to run in safe mode by going through command prompt at the start
up repair options
-looked through the bio settings for anything unusual

my specs are q9650, 8bg xms2 gtx 560ti 2gig 250gig hitachi hdd
 
I think normally a black screen with blinking underscore is to do with the MBR. I would boot into a Windows and try automatic repair.

If that doesn't work, try the bootrec commands from the CMD inside the disk.

Bootrec.exe /fixboot
bootrec.exe /fixmbr
bootrec.exe /rebuildbcd

hi thanks for the reply, it doesnt have a blinking underscore just a crsor which i can move should i try the bootrec.exe /fixboot comand?
 
Back
Top Bottom